Shandong ReeWo hydraulic technology co.Ltd.
RMR Wheel Motor
The RMP and RMR series cycloidal hydraulic motors are both low-load axial-flow hydraulic motors. Their external connection dimensions are essentially identical, and their cycloidal parameters are completely consistent.
Keywords:
Category:
RMP/RMR Series Motors
The RMP and RMR series cycloidal hydraulic motors are both low-load, shaft-ported hydraulic motors. Their external connection dimensions are essentially identical, and their cycloidal parameters are completely consistent. Both feature a pin-and-socket stator-rotor assembly. The stator sleeve diameter of the RMR motor is slightly larger than that of the RMP, enabling it to withstand higher system pressures. The RMP is suitable for applications with lower system pressures and limited installation space. For small-displacement motors (50 ml, 63 ml, 80 ml), the RMR series motors are recommended.
Performance Parameters of RMP/RMR Series Motors
Discontinuous pressure refers to the pressure that the motor’s oil inlet is allowed to withstand, while continuous pressure refers to the pressure difference when the two oil ports are operating continuously.
The motor is not permitted to operate simultaneously under conditions of high speed and high pressure.
Intermittent operating conditions—refers to a motor operating under these conditions for no more than 10% of each minute.
Recommended hydraulic oil: viscosity of 37–73 cSt, filtration accuracy: ISO 18/13, and maximum system temperature not exceeding 80℃.
The shaft seal can withstand a back pressure of 10 MPa. It is recommended that the motor’s back pressure not exceed 5 MPa; if the back pressure exceeds 5 MPa, it is advisable to connect an external drain line. Before and during operation, the motor’s cavity must always be kept fully filled with hydraulic oil to ensure proper lubrication and cooling of the motor.
It is strongly recommended that the motor run at 30% load for about one hour before operating at full load, allowing the motor to undergo sufficient break-in.
Application Cases
Product Center