PRODUCTS CENTER
RMR wheel motor
Classification:
RMP/RMR series cycloidal hydraulic motors are light-loaded shaft-distributing hydraulic motors. The external dimensions of the two are basically the same, and the cycloidal parameters are completely consistent. All of them are insert-toothed stator and rotor pairs.
Keywords:
TEL：+86-13964921111
Detailed introduction
Graphic Details
RMP/RMR series cycloidal hydraulic motors are light-loaded shaft-distributing hydraulic motors. The external dimensions of the two are basically the same, and the cycloidal parameters are completely consistent. All of them are insert-toothed stator and rotor pairs. The stator sleeve diameter of RMR motor is slightly larger than RMP, which can withstand greater system pressure. RMP is suitable for environment with low system pressure and small assembly space, small displacement motor (50 Ml, 63ml, 80ml) It is recommended to use the RMR series motor.
RMP/RMR series motor performance parameters
The discontinuous pressure refers to the pressure that the motor inlet can withstand, and the continuous pressure refers to the pressure difference between the two ports when it is continuously operated.
The motor is not allowed to be used at both maximum speed and maximum pressure.
Discontinuous operating conditions --- means that the motor does not exceed 10% per minute during this condition.
Recommended hydraulic oil: viscosity 37-73cSt, filtration accuracy: ISO18/13, system maximum temperature does not exceed 80 °C.
The shaft seal can withstand 10Mpa back pressure. It is recommended that the motor back pressure should not exceed 5Mpa. When it exceeds 5Mpa, it is recommended to connect the external drain pipe. Before and during operation of the motor, ensure that the chamber is always filled with hydraulic oil to allow the motor to be well lubricated and cooled.
It is strongly recommended that the motor be operated with a 30% load for approximately one hour before full load operation to allow the motor to be fully run-in.
Shandong ReeWo hydraulic technology co.Ltd.is a high-tech private enterprises,Located in jining,shandong province,high-tech industrial development zone,the seventh industrial park.
MORECONTACT US
Tel：+86-139 6492 1111
Tel：+86-151 6637 3779
E-mail：yinfulin@hotmail.com
Address: Xingda Industrial Park, Shanbo Road, Jining High tech Zone
Mobile site
Copyright © Shandong ReeWo hydraulic technology Co. Ltd. Powered by 300.cn